SV0360 ABNORMAL CHECKSUM (INT) The checksum alarm occurred on the built-in pulse coder. This alarm is generated only for the master axis. SV0350 EXCESSIVE TORQUE DIFFERENCE In synchronization control, the values specified by the torque commands for the master and slave axes exceeded the value set in parameter No. 1716. This alarm is canceled by resetting the control. ALARM LIST APPENDIX B-63325EN/03 Number Message Contents SV0128 ABNORMAL TORQUE (4TH SPDL) An abnormal load was detected at the No.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |